Wells M4200 Owner's Manual page 13

BUTTON DESCRIPTION / FUNCTION
VIEW View current temperature & setpoint temperature by pressing and holding 3 seconds.
TEMP When baking multiple products can view time remaining. In program mode arrow
indicates cursor will move to the right when entering data.
PROG Press and hold for 5 seconds to enter into program mode. After entry and pressing
PROG button can access the following areas. When asked for password, enter 9793.
1) Temp Cal - - Not password protected. Used for calibrating temperature
2) View menu - - Not password protected. In this mode can view each product setting by
pressing the appropriate button. Cannot edit or change settings in this mode.
3) Edit menu - - Password protected (Authorized Personnel Only). In this mode can
view and change settings, names, alarms, etc. in buttons 1 – 0
4) Service menu - - Password protected (Authorized Personnel Only).
Contains the following information
a) Unit ID #
b) Scale ºF
c) Temp Comp YES
d) Energy Saver NO
e) Default Menu
5) Transfer menu - - Password protected (Authorized Personnel Only).
Contains the following functions;
a) Read Menu Card
b) Write Menu Card
c) Restore Menu
d) Restore Systems
6) Systems info - - Not password protected. Contains the following information used to
determine system versions and updates.
a) Model #
b) Bios Version
c) O/S Version (operating systems)
d) Default Menu
NOTE: Program button is used as the enter key for accepting data and / or moving to the next function.
START Actuates the timing cycle for baking. In programming mode used to exit and save
Buttons 0 – 9 Used to select stored menu items. In programming mode also used to enter alpha
sequences to change or enter product names.
Buttons 2 & 8 Select menu items. Also used in the programming mode for scrolling up or down
numerically for temperature calibration, and changing no to yes or vice versa.
UTILITY 1) Contains cool down function.
2) Used to switch between dayparts by holding UTILITY button for 3 seconds then
pressing PROG.
3) In program mode arrow function is used to move cursor to the left
CANCEL 1) Used to cancel alarms.
2) In program mode used to exit out without saving.
3) Used to cancel a bake cycle. Press VIEW to display desired bake cycle, then press
CANCEL to cancel that bake cycle.
IMPORTANT PROGRAMMING NOTE: This oven is pre-programmed from the factory and does not
require programming adjustments under normal circumstances.
FEATURES & OPERATING CONTROLS (continued)
f) Rise Time
g) Detect Current
h) Time (clock, real time)
Controller will read information from the card
Controller will transfer information to the card
Restores default menu settings (Use Menu Card)
Restore default operating systems settings (Use System
Card)
11
10:00
YES