Removing The Exifu Cover (Figure 2-8); To Install An Exifu Pcb - NEC UX5000 Hardware Manual

2.4.2.2

Removing the EXIFU Cover (Figure 2-8)

1.
2.4.2.3

To install an EXIFU PCB:

1.
2.
3.
4.
Chapter 2
Press on the right-hand side of the EXIFU cover and pull the cover open. Slide the cover
slightly to the left to unhook the 3 hooks which hold on the cover.
Press here to pull
the cover.
Hooks
This cover has three Hooks
at the left hand side.
Figure 2-8:
• Do not remove or install this PCB with the power on.
Remove the EXIFU cover as described previously from each of the KSUs.
Carefully remove the blank filler piece on the cover to allow for the EXIFU connectors.
For the Controlling KSU-B1 (with the CCPU), install the EXIFU-B1 into the slot.
For the Base KSU-B1(s), install the EXIFU-E1 into the slot in each of the additional KSUs.
Screw the PCB to the cabinet using the screw provided.
REMOVING THE EXIFU COVER
Chapter 2 - PCB Installation and Startup
2 - 25