4.14.7.2 Using The Psa-R Adapter - NEC UX5000 Hardware Manual

Chapter 4 - Telephones and Optional Equipment

4.14.7.2 Using the PSA-R Adapter:

With an analog line connected, the PSA-R adapter will automatically switch to the analog line
connection when power is lost.
Placing Calls:
1.
Answering Calls:
1.
2.
Adjusting the Ring Volume
1.
When Power is Restored
1.
Setting for Pulse or DTMF
1.
4 - 52
When the PSTN line has been activated either manually by the switch or due to a power
failure, use the dial pad buttons (0-9, *, #) to place an outside call.
●
Other than receiving calls, no other keyset functions are available.
●
The # and * keys are not functional if the DTMF/DP selector switch is set to pulse mode.
When a call is received, the PSA-R adapter rings using the piezoelectric buzzer and the LED
blinks. If the PSTN-IP/Digital Switch is set to PSTN (functions as power failure telephone),
answer the call by pickup up the handset. If the switch is set to the IP/Digital position, the
telephone functions as a system telephone when there is power and as a power failure
telephone when the power is off.
If an analog line is connected, the PSTN-IP/Digital selector switch can be used to switch to
the analog line manually (without having to lose power). If an incoming call is received on the
analog line while the PSA-R is connected to a regular telephone system trunks, the
terminating LED blinks and a ring tone is heard.
●
You must complete your present call prior to answering the analog trunk call, otherwise
your original call will be disconnected.
●
Other than receiving calls, no other keyset functions are available while used as a power
failure telephone (PSTN).
Use the Volume Control buttons located on the PSA-R adapter to adjust the volume level.
●
Other than receiving calls, no other keyset functions are available.
The IP keyset restarts and reconnects to the network LAN. However, if you are on a PSTN
call when the power is restored, your conversation will continue until the handset is placed
into the cradle. Once this occurs, the IP keyset will restart and reconnect to the LAN. If the
PSTN mode was manually set by the switch, it must be set back to the IP/Digital position
before the adapter will switch modes.
●
Other than receiving calls, no other keyset functions are available.
Set the DTMF/DP Selector Switch on the bottom of the telephone to either DTMF or DP.
Chapter 4