Chapter 4 - Telephones and Optional Equipment
4.14.2
16LK Line Key Module
This optional unit connects to the side connector to the right of the telephone. This unit provides 16 additional
keys which can be programmed as line/loop keys or Programmable Function Keys. Keysets with a 16LK Line
Key Module installed can also have a 60-Button DSS Console connected.
Once defined in system programming, these keys are used the same as the line, loop, or Programmable
Function keys on the digital keyset or IP terminal.
✎
This module is connected to the keyset/terminal using a special cable. This cable is provided with the module.
For specifications, refer to Section 6-1 UX5000 SYSTEM SPECIFICATIONS in Chapter 6 - Specifications and
Parts List on page 6-1.
4.14.2.1
Installing the 16LK Module:
1.
2.
3.
4.
5.
6.
7.
4 - 40
Option Compatibility
IP Terminal
IP-CTS
Enhanced
✔
✔
Unplug any cables from the keyset (line cord, LAN cable, power adapter).
Remove the side panel from the right-hand side of the telephone.
Hook a finger on the hollow indent on the back of the telephone
(near the top) and gently pull off the panel.
Connect the adapter so the side of the telephone aligning the tabs
up.
Secure the adapter with the two screws provided.
Turn the telephone upside down.
Open the panel located on the bottom of the telephone and
connect the cable from the 16LK adapter.
Turn the telephone right-side up and reconnect any required
cables.
Digital Keyset
Value
Enhanced
✔
NA
Value
NA
Chapter 4