Dial Pad Replacement; Dial Pads; Installation; Programming The Digital Telephone For The Dial Pad - NEC UX5000 Hardware Manual

S 4-3
ECTION

DIAL PAD REPLACEMENT

4.3.1

Dial Pads

With the UX5000 digital keysets or IP terminals, replacement dial pads are available which can enhance the
operations of the telephone for a specific use (such as Hotel/Motel, ACD, retirement facility). The following
installation instructions can be used for Value 2-Button or 6-Button, Enhanced 12-Button or 24-Button, or
DESI-Less telephones.
4.3.2

Installation

1. Remove any cable from the telephone (line cord, LAN cable, AC power).
2. Remove the existing dial button kit by prying up the upper and lower plastic panels covering the dial pad.
Also remove the designation sheet used for labelling the telephone.
3. Lift off the dial button kit while pulling towards the front of the telephone.
4. Insert the tabs of the new dial button kit located at the base of the dial button kit into the notches on the
telephone.
5. Push the upper portion of the dial button kit down until it clicks into position.
6. Press the buttons one by one to make sure that they are not stuck or that they have too much play.
7. Reattach the designation sheet and the upper and lower panels to the telephone.
4.3.3

Programming the Digital Telephone for the Dial Pad

1. With the telephone not plugged in and the handset on-hook, press the "4" and "6" buttons on the dial pad
and connect the telephone cables.
●
This places the phone into Service Class R/W mode. The MW LED should be lit.
2. Press "2" to enter the Button Kit mode.
●
The MW LED should flash.
Chapter 4
Chapter 4 - Telephones and Optional Equipment
4 - 9