2.7.5.1
Setting the SW1-SW2 Switches
In the following cases, the SW1-SW2 switches (6-8 bits on both SW1 and SW2) should be set to the
ON position (default):
Otherwise, the SW1-SW2 switches should be set to the OFF position. If the last port of the ISDN
terminal is connected to a modular rosette with a termination resistor or when using an ISDN
terminal which provides a termination resistor, refer to the ISDN terminal documentation for further
details.
Chapter 2
Figure 2-35:
●
When the channel is assigned as a T-Bus Point-to-Point.
●
With T-Bus Point-to-Multipoint and if the system is connected at the end of the
multipoint.
Chapter 2 - PCB Installation and Startup
BRI PCB - SOLDER SIDE
2 - 69