Cruise Speed* (Cruise Control System - Ccs) - Seat altea Owner's Manual

detected while driving forward. The optical
display changes to towing mode.
Fault messages
If you hear a long beep for a few seconds and
the LED on the switch * starts flashing
when you switch on the parking aid, a system
fault has occurred. Contact a SEAT official
service or specialised workshop.
Note
If the fault is not corrected before you switch
off the ignition, it will only be indicated by
the flashing LED on the switch  the next
time you switch on the parking aid.
Cruise speed* (cruise control
system - CCS)
Description
The CCS is able to maintain the set speed in
the range from approx. 30 km/h (19 mph) to
180 km/h (112 mph).
Once the speed setting has been saved, you
may take your foot off the accelerator.
1) Depending on the model version
142
Operation
WARNING
It could be dangerous to use the cruise con-
trol system if it is not possible to drive at con-
stant speed.
● Do not use the cruise control system when
driving in dense traffic, on roads with lots of
bends or on roads with poor conditions (with
ice, slippery surfaces, loose grit or gravel), as
this could cause an accident.
● Always switch the cruise control system off
after using it in order to avoid involuntary
use.
● It is dangerous to use a set speed which is
too high for the current road, traffic or weath-
er conditions. Risk of accident.
Note
The cruise control cannot maintain a constant
speed when descending downhill. It will in-
crease due to its own weight. Use the foot
brake to slow the vehicle.
Switching the cruise control system
on and off
Turn signal and main beam head-
Fig. 135
light lever: switch and rocker switch for the
cruise control.
Switching on the cruise control system
›››
Push the switch Fig. 135
–
B
ON .
Switching off the cruise control system
Either push the switch to the right to
– B
OFF or turn the ignition off when the vehicle
is stationary.
When cruise control is on and a speed is pro-
grammed, the indicator  on the dash panel
1)
is lit.
If the cruise control system is switched off,
the  symbol is switched off. The system will
to the left to