Johnson J10RLSRD Service Manual page 314

SAFETY
If electrical parts are replaced or even removed from the outboard, check the following:
Wire and high voltage lead routing
• As shown in service manual
• Away from moving parts which could cut wires or wire insulation
• Away from engine cover latches which can catch and cut insulation from high voltage spark plug leads
Sleeves, boots, shields
• In position (to avoid shock hazard)
• Not torn or cracked
Metal Clamps - Tie Straps
• Position as shown in manual
Screws, Nuts, Washers
• Tighten firmly-these keep
clamps in position and ends
of wires from sparking
• Where lock washers are
called for, use them
Spark Plug Boots
• Not torn or cracked
~~~
. . . . . . . • Fully pushed onto spark
plug
\ ~~~~~~~~~~~i"."
Spark Plugs
• Avoid rough handling that
could crack ceramic part of
plug. (Sparks may jump
In transom area:
All Connections
• Clean
• Tight
(Prevents sparks)
across outside of plug.)
Electric Cable
• Not rubbing on sharp objects
• Enough slack to allow full turn-
ing without pull loads on cable
(prevents sparks)
Batteries
• Secure in approved battery
box or battery tray
• Battery terminals insulated
• No strain on cables
8-9
E
o
U
Qj
)(
~
Qj
~
ii
E