Johnson J10RLSRD Service Manual page 133

IGNITION
IGNITION PLATE SERVICING
Lubricate the ignition plate bearing groove with
Moly Lube.
1
1. Groove
DR2618
Apply Nut Lock to the threads of the ignition plate
screws. Insert needle-nose pliers into slots in the
ignition plate bearing and compress bearing while
guiding the ignition plate into position.
Align the ignition plate with the retainer plate.
Torque the screws to 25 to 35 in. Ibs. (2.8 to 4.0
N·m).
Connect and adjust spark advance link. Refer to
SYNCHRONIZATION AND LINKAGE ADJUST-
MENTS - 9.9/15 on p. 70.
Check for sufficient slack on ignition component
leads during full advance movement of the ignition
plate.
132
25/30
MODELS
Place the retainer plate, washers, and pilot ring on
the powerhead. Be sure washers are placed
between the pilot ring and powerhead.
Align pilot ring with four screw holes in power-
head. Apply Nut Lock to threads of the four pilot
ring screws. Install the screws and torque to 48 to
60 in. Ibs. (5 to 7 N·m).
1
1
1. Screws
47303
Apply Moly Lube to the thrust washer, and place
into the machined groove of the ignition plate.
2
1
1. Thrust washer 48708
2. Machined groove