Johnson J10RLSRD Service Manual page 216

RAND
TE
MODELS
Install the neutral start plunger and spring through
the component bracket. Using a pin, secure
plunger as shown.
1
After checking ignition plate routing, install the
component bracket, neutral start plunger, lockout
lever, pivot screw, and flat washer, as shown.
Tighten pivot screw to 60 to 84 in. Ibs. (7 to 9
N·m). Remove the pin securing the plunger.
2
1
1. Screw
47176
2. Washer
POWERHEAD
INSTALLATION - 25/30
Rotate the propeller shaft and shift the engine into
REVERSE . Place the actuator cam link into the
shift actuator cam. Secure the link with the washer
and pin .
1. Actuator cam link 47171
2. Shift actuator cam
Seat shift lever socket on the lever. Snap socket
onto the stud. Secure the socket with washer and
retainer pin.
E
o
o
~
><
~
Qj
~
i:i
215 E