Johnson J10RLSRD Service Manual page 192

Lift the crankshaft out of the cylinder block.
Replace the rod caps on the rods. Orient them
exactly as they were before you removed them.
Install the screws finger tight.
Rotate the powerhead so the cylinder head faces
up. Remove the cylinder head and gently push up
on the connecting rods to remove number 1 and
number 2 piston assemblies. Protect the condition
of the piston by packing paper towels between the
connecting rod and piston. Do not allow the con-
necting rod to contact the inside of the piston skirt
during handling.
POWERHEAD
DISASSEMBLY - 25/30
Remove the upper crankshaft seal and bearing.
Discard the seal and clean and inspect the bear-
ing.
2
1
1. Seal
1524
2. Bearing
Remove a-ring from crankshaft sleeve and
inspect. Replace if necessary.
Inspect crankshaft sleeve and replace if neces-
sary. To remove, use Slide Hammer, PIN 432128,
and Large Puller Jaws, PIN 432129.
E
o
o
:;j
)(
~
Qj
~
i::i.
191
~