Johnson J10RLSRD Service Manual page 106

ELECTRICAL
ELECTRIC STARTER SERVICING
IMPORTANT: Reversing these brushes will Install pinion base and pinion on armature shaft.
cause starter motor to run backwards.
Install brush holder, brush springs, and ground
brushes. Screws secure ground brush leads and
holder. Insert insulated brushes in holder.
30716
Assemble end cap to frame and field, aligning
notch and rib. A suitable tool for holding brushes
in place can be made from a putty knife.
Put a drop of oil on thru-bolts before assembling
starter motor. Install thru-bolts. Torque thru-bolts
95 to 100 in. Ibs. (11 to 12 N·m). Seal with Black
Neoprene Dip.
Install spacer and spring on armature shaft.
38532
Install cup on armature shaft. Press cup down on
spring and install retaining ring in groove on arma-
ture shaft.
Pull cup up over retaining ring and make sure ring
seats in shaft groove and cup groove to allow full
bendix travel.
E
o
o
:;j
)(
~
Qj
~
i::i.
105
~