Johnson J10RLSRD Service Manual page 236

Secure the stop button ground lead behind the
ignition coil on the lower screw, with starwasher
next to block.
MIDSECTION
STEERING HANDLE - TILLER MODELS
Thread the throttle cable anchor onto the cable
housing until anchor is flush with end of threads.
Thread the cable end connector on the cable until
seated.
2
1
3
1. Throttle cable anchor
DR4947
35282 2.
Threads
3. Cable end
Use Pin Insert Tool, PIN 322697, to install the stop
button black wire into the 5-pin Amphenol plug.
35279
Connect the Amphenol connector. Secure the
connector to the ignition coil post with a tie strap.
Position the throttle cable connector into throttle
lever and insert pin. Position throttle cable anchor
on powerhead and secure with shoulder screw
and washer.
35281
Hook cable retainer around throttle cable and
install air silencer.
Install manual starter and lower motor covers.
To adjust the throttle cable, refer to SYNCHRONI-
ZATION AND LINKAGE ADJUSTMENTS -
9.9115 on p. 70.
235
I