Johnson J10RLSRD Service Manual page 212

screws, tighten the remaining eight screws and
torque 60 to 84 in. Ibs. (7 to 9 N·m).
Tighten the three lower crankcase head screws
and torque 60 to 84 in. Ibs. (7 to 9 N·m) .
Apply Gasket Sealing Compound to outside metal
casing of a new upper main bearing seal. Using
Seal Installer, PIN 321539, install the seal with its
lip facing down.
Lightly coat both sides of a new cylinder head
gasket with Gasket Sealing Compound. Install the
gasket and cylinder head. Tighten the screws in
the sequence shown and torque 216 to 240 in.
Ibs. (24 to 27 N·m).
POWERHEAD
ASSEMBLY - 25/30
Place the thermostat and the seal in the cavity
provided in the cylinder head. Set the spring on
top of the thermostat.
3----,~
__ ,
I
1 -_ _ _
~
2-
1. Thermostat
2. Seal
3. Spring
COA1452
Apply Gasket Sealing Compound to both sides of
a new cylinder head water cover gasket; install the
gasket and cover. Starting with the center screws
and working outward, tighten the screws and
torque 60 to 84 in. Ibs. (7 to 9 N·m). Install the cyl-
7
inder head screws dry. Do not use sealant on
threads.
24941
Install the inner and outer exhaust covers . Coat
Torque Sequence
COA1476
both sides of two new gaskets with Gasket Seal-
ing Compound. Install the screws. Starting with
the center screws and working outward, tighten
E
o
o
~
><
~
OJ
~
c.
211 E