Johnson J10RLSRD Service Manual page 303

MANUAL STARTER
ASSEMBLY
Install the rewind spring into the starter housing.
Locate the outer loop of the rewind spring on the
pin in the starter housing. Press down through the
holes of the adapter release plate to transfer the
rewind spring into the starter housing.
2
1
1. Outer loop
2684
2. Pin
Place the starter spring shield with holes onto the
pulley.
0648
302
Bend the inside loop of the rewind spring in
toward the center of the starter housing. Engage
the pin of the pulley with the inner loop of the
rewind spring and install the pulley in the starter
housing.
~::------2
1
1. Inside loop
2679
2. Pin
Lightly apply Trip/e-Guard grease or Lubrip/ate
777 to the spindle bushing and pawl pins on the
pulley. Install the bushing and the shim into the
starter pulley. Next install the friction plate, links,
and pawls. Secure the pawls with the retaining
clips.
Lightly apply Trip/e-Guard grease or Lubrip/ate
777 to the spindle. Install the spindle, friction ring,
and spring washer.
~f---1
2 - - - - -C§)
~-----3
5--------'~
(Qi - - - - - - - - 6
4 - - -t)
(.8.)
3
1. Spindle bushing
DR1743A
2. Shim
3. Friction plate
4. Spindle
5. Friction ring
6. Spring washer
IMPORTANT: The flat section of the friction ring
and spindle must be aligned.