Johnson J10RLSRD Service Manual page 237

MIDSECTION
STEERING HANDLE - TILLER MODELS
25/30
MODELS
Apply Trip/e-Guard grease to the steering handle
sleeve. Place the sleeve into the steering bracket.
Attach the steering handle to the steering bracket.
Tighten the screw and nut so the steering handle
can pivot and maintain any position.
Secure stop button ground lead to bottom ignition
coil mounting screw. Tighten screw to a torque of
48 to 96 in. Ibs. (5.4 to 10.8 N·m).
Thread the anchor onto the cable housing 2 in.
(50 mm), plus or minus one turn , from the end of
the cable sleeve. Secure anchor in place with
shoulder screw and spacer. Next, thread the con-
nector onto the cable end.
2 in.
(50 mm)
~ ~
50174
Position the connector on the throttle arm ball
joint. Secure the connector using the washer and
spring retainer.
45035
Secure the bracket to the lower engine cover
Use Pin Insert Tool, PIN 322697, to install stop
button lead into plug. Connect the 5-pin Ampheno/
connector. Secure connector with wire retainer.
236
using shoulder screw and spacer.
To adjust the throttle cable, refer to SYNCHRONI-
ZATION AND LINKAGE ADJUSTMENTS -
25/30 on p. 73.
E
o
o
~
><
~
Qj
~
i:i
E