Johnson J10RLSRD Service Manual page 288

Insert one detent ball, then the spring, then the
other detent ball. Push down on the ball and slide
the tool back until you feel the ball slip into the
detent.
1. Detent ball
26728
Install the propeller shaft and detent tool in gear-
case. Make sure the following occurs:
• Propeller shaft must engage forward bearing.
• Tool ramps must engage clutch dog ramps.
• Hold tool firmly against clutch dog.
• Gently tap propeller shaft with a rawhide mallet
to seat detent assembly.
GEARCASE
ASSEMBLY - 25/30
Remove detent tool. Slide the reverse gear down
the propeller shaft and into the gearcase .
1
----'~-2
1. Reverse gear COB3051
2. Bushing
Coat the reverse gear bushing with oil. Slide the
bushing down the propeller shaft, seating the
bushing into the reverse gear.
Holding the shifter yoke a with long-nose pliers,
install the yoke at a tilted position, locating top of
yoke into upper gearcase cavity.
2
1----.
1. Shifter yoke COA3229
2. Top of yoke
Engage the shifter yoke hook onto the shifting
lever clevis pin in bottom of the gearcase cavity.
==""- - - - - 1
1. Shifter yoke hook COA3230
287
II