Johnson J10RLSRD Service Manual page 298

Remove the starter spindle screw and locknut.
Hold the pulley down in housing and lift out spin-
dle. Carefully lift out pulley, leaving spring in hous-
ing.
1
1. Screw and locknut
~
WARNING
~
Do not remove spring with housing facing
up. Do not lift spring out of housing by
hand or with pliers. Spring is under ten-
sion and will cause injury if accidentally
released. Keep fingers away from uncoil-
ing spring.
Turn starter housing over and jar on bench to
remove spring.
25/30
MODELS
MANUAL STARTER
DISASSEMBLY
~
WARNING
~
Wear safety glasses while disassembling
and assembling manual starters to avoid
personal injury caused by rewind spring
tension.
Pull the starter rope out far enough to tie a slipknot
in the rope. Pry the starter rope anchor out of the
handle. Remove the handle, release the slipknot,
and ease the pulley back until the rewind spring is
fully unwound.
2 - -_ _
--..1
_---1
1. Anchor
0645
2 . Handle
Remove the spindle screw nut.
1----
j
1. Nut
COA1341
E
o
U
Qj
)(
~
Qj
~
ii
297 E