Johnson J10RLSRD Service Manual page 206

Apply Needle Bearing Assembly Grease to the 28
wrist pin bearings. Install the bearings in the wrist
pin bore. Align the bearings in the bore using
Wrist Pin Bearing Tool, PIN 336660 .
Wrist Pin Bearing Tool
1. Bearings
.-----1
24911
Place the two wrist pin thrust washers on the tool
with flat side of the washers facing out.
j----_-
1
- -
-
1. Wrist pin thrust washers 24910
-
POWERHEAD
ASSEMBLY - 25/30
Install the wrist pin through the piston and con-
necting rod, pushing the tool out through the pis-
ton.
24442
Using Cone, PIN 318600, and Driver, PIN 318599,
install new wrist pin retaining rings in both wrist
pin retainer grooves of piston. When installed, gap
of the ring should be positioned opposite notch in
the piston.
2
DR3480
1
IMPORTANT:
The connecting rod has no spe-
cific orientation. Support the piston in Piston Cra-
dle, PIN 326573. Oil the wrist pin bore and wrist
pin.
1. Gap in retaining ring
2. Notch in piston
Repeat these steps for each piston.
24909
205
I
E
o
U
Qj
)(
~
Qj
~
ii
E