Table of Contents
Advertisement
3-8
Configuring the Module
3. Click on the Chan. 1 tab
area accordingly. In this example, Cmd/Ref and all Datalinks are
used.
Figure 3.6 Chan. 1 Tab Data Screen
Select the desired Idle Action. Note that the Fault Config Data area
(Figure
Figure 3.7 Chan. 1 Tab Data Screen with Idle Action - Send Flt Cfg Enabled
4. For each additional channel being used, select its respective tab, set
the desired I/O configuration, and enable the appropriate idle action.
(Figure
3.7) can only be accessed if Send Flt Cfg is enabled.
3.6) and set the I/O Config data
Advertisement
Table of Contents
