Quick Start - Allen-Bradley 1769-SM1 User Manual

1-6 Getting Started

Quick Start

This section is provided to help experienced users quickly start using the
1769-SM1 Compact I/O to DPI/SCANport module. If you are unsure
how to complete a step, refer to the referenced chapter.
Step Action
1 Review the safety precautions for the module.
2 Verify that the drive is properly installed.
3 Install the module.
Verify that the controller is not powered. Then, connect
the module to the controller backplane bus, and to the
drive using a Bulletin 1202-Cxx communications cable.
4 Apply power to the module.
The module receives power from the controller. Apply
power to the controller. The MODULE indicator should
be green. If it flashes red, there is a problem. Refer to
Chapter
5 Configure the module for your application.
Set the following parameters for the module as required
by your application:
• I/O configuration.
• Fault actions.
6 Apply power to the drive.
Verify that the drive is installed properly, and then apply
power to it.
7 Configure the controller to communicate with the
module.
8 Create a ladder logic program.
Use a programming tool such as RSLogix to create a
ladder logic program that enables you to do the
following:
• Control the module and connected drive.
• Monitor or configure the drive using Explicit
Messages.
8, Troubleshooting.
Refer to...
Throughout this manual
Drive User Manual
Chapter 2,
Installing the Module
Chapter 3,
Configuring the Module
Network Cable System
Planning and Installation
Manual
Depending on controller
type:
•
Chapter 5,
MicroLogix 1500
Ladder Example
Program
•
Chapter 6,
CompactLogix Ladder
Example Program
•
Chapter 7,
ControlLogix w/
1769-ADN DeviceNet
Ladder Example
Program