Table of Contents
Advertisement
2-6
Installing the Module
Figure 2.5 1769-SM1 Module with Remote 1769-Based Adapter
Mounting Hole
Dimension
Panel Mounting Procedure Using Module as a Template
The following procedure enables you to use the assembled modules as a
template for drilling holes in the panel. Due to module mounting hole
tolerance, it is important to follow these steps:
1. On a clean work surface, assemble no more than three modules.
2. Using the assembled modules as a template, carefully mark the
center of all module-mounting holes on the panel.
3. Return the assembled modules to the clean work surface, including
any previously mounted modules.
4. Drill and tap the mounting holes for the recommended M4 or #8
screw.
5. Place the modules back on the panel, and check for proper hole
alignment.
6. Attach the modules to the panel using the mounting screws.
50 mm
35 mm
(1.97 in)
(1.38 in)
40 mm
35 mm
(1.58 in)
(1.38 in)
NS
MS
IO
DIAG
DIN Rail
Center Line
70 mm
35 mm
(2.76 in)
(1.38 in)
35 mm
35 mm
35 mm
(1.38 in)
(1.38 in)
(1.38 in)
MODULE
CH1
CH2
CH3
C
H
1
C
H
2
C
H
3
14.7 mm
(0.58 in)
28.5 mm
(1.12 in)
Advertisement
Table of Contents
