Table of Contents
Advertisement
Assembling the Module to the Controller
The 1769-SM1 module can be attached to adjacent controller modules
before or after mounting. For mounting instructions, see
Mounting on page 2-4
a system that is already mounted, see
System on page
Figure 2.2
and the following procedure shows you how to assemble the
Compact I/O system.
Figure 2.2 Assembling 1769-SM1 Module to Compact I/O System
A
C
1. Disconnect power.
2. Check that the bus lever (A) of the 1769-SM1 module is in the
unlocked (fully right) position.
3. Use the upper and lower tongue-and-groove slots (B) to secure the
modules together.
4. Move the 1769-SM1 module back along the tongue-and-groove slots
until the bus connectors (C) line up with each other.
5. Use your fingers or a small screwdriver to push the bus lever back
slightly to clear the positioning tab (D).
6. Move the 1769-SM1 module's bus lever fully to the left (E) until it
clicks. Ensure it is locked firmly in place.
ATTENTION: Risk of equipment damage exists. When attaching the
1769-SM1 module to a Compact I/O system, it is very important that
!
the bus connectors are securely locked together to ensure proper
electrical connection. Failure to do this may cause an electrical arc,
which can cause personal injury or equipment damage.
or
DIN Rail Mounting on page
2-7.
B
B
Installing the Module
2-7. To work with
Replacing the Module within a
D
F
2-3
Panel
E
G
Advertisement
Table of Contents
