Connecting The Module To The Drive; Applying Power - Allen-Bradley 1769-SM1 User Manual

Connecting the Module to the Drive

1. Plug one male end of a 1202-C* communications cable into a desired
port (CH1, CH2 or CH3) on the 1769-SM1 module.
2. Plug the other male end of the cable into the port on the desired
drive.
Note: For EMC regulatory compliance, there is a maximum cable
distance limit per channel. Please see
page A-2 for more information. For general cable information, please
see DPI/SCANport Cable Requirements/Recommendations on
page A-2.

Applying Power

ATTENTION: Risk of equipment damage, injury, or death exists.
Unpredictable operation may occur if you fail to verify that parameter
!
settings are compatible with your application. Verify that settings are
compatible with your application before applying power to the drive.
1. Apply power to the controller. The status indicators can be viewed on
the front of the 1769-SM1 module after power has been applied.
2. The module is assigned a unique network address by the bus master
during initialization.
3. Apply power to the drive. When you apply power to the 1769-SM1
module, controller, and network for the first time, the status
indicators should be green after an initialization. If the status
indicators go red, there is a problem. Refer to
Troubleshooting.
Installing the Module
Regulatory Compliance on
Chapter
2-9
8,