Table of Contents
Advertisement
1769-SM1 Settings
The 1769-SM1 used in the example program has the following
parameter settings:
Parameter
No.
Name
07
I/O Config 1
24
I/O Config 2
41
I/O Config 3
Note that the module must be reset using Parameter 02 - [Reset
Module] before these parameter settings take effect.
!
Refer to
Enable/Status, Logic Command/Status, Reference/Feedback, and
Datalinks.
CompactLogix Example Program
Figure 6.2 CompactLogix Ladder Logic Main Program
Execute the 1769-SM1 Channel 1 subroutine.
Execute the 1769-SM1 Channel 1 subroutine.
0
Execute the 1769-SM1 Channel 2 subroutine.
Execute the 1769-SM1 Channel 2 subroutine.
1
Execute the 1769-SM1 Channel 3 subroutine.
Execute the 1769-SM1 Channel 3 subroutine.
2
(End)
CompactLogix Ladder Example Program
Setting
11111
11111
11111
ATTENTION: Risk of injury or equipment damage exists.
If the module is transmitting I/O that controls the drive, the
drive may fault when you reset the module. Determine how
your drive will respond before resetting the module.
Chapter 4
for information about the I/O Image layout, Channel
CompactLogix w/ 1769-SM1 DPI/SCANport Module example program
CompactLogix w/ 1769-SM1 DPI/SCANport Module example program
Description
CH1 Command/Status and all Datalinks are enabled
CH2 Command/Status and all Datalinks are enabled
CH3 Command/Status and all Datalinks are enabled
JSR
Jump To Subroutine
Routine Name Channel_1
JSR
Jump To Subroutine
Routine Name Channel_2
JSR
Jump To Subroutine
Routine Name Channel_3
6-3
Advertisement
Table of Contents
