4.4
Unloading Filament
4-10
(4-10) Tap [Tool]-[Unload] and the extruder starts heating up.
、
4-11
(4-11) After the extruder reaches 220℃, the printer will sound a beep to prompt you
to unload the filament from the extruder. Press the spring presser and gently pull the
filament out.
Note: Do not pull out the filament with force as it will damage the gears. If the
melted filament has cooled down in the extruder, please repeat the steps above.
28
Finder User Guide |
www.ff3dp.com