Unloading Filament - Flashforge Inventor 2 Quick Start Manual

Unloading Filament

1. Pull filament guide tube out of filament intake,
leave filament 10cm to pull filament easily.
3. Tap [Filament].
Press here
5. When heating to target temparture, press
spring presser and push filament down through
for 3 seconds, until you see steady filament
coming out from nozzle.
Please follow steps below if you need to unload filament in
daily use.
Push filament down
through for
3 seconds
14
2. Tap [Tools].
4. Tap [Unload].
Unload started, press down on the
spring lever and withdraw filament
Extruder
Press here
6. Then pull out vertically quickly and release
spring presser. Tap [Finish], go back. Tap return
arrow to go back to home screen.
Done
Withdraw
filament