Unloading The Filament Using Lcd Panel - Flashforge Creator Pro User Manual

OK
pressing the key on the keypad, and the nozzle should start extruding filament. If
not, keep pressing the

7.3 Unloading the Filament Using LCD Panel

CAUTION
If you just finished your printing or already extruded the filament and want to withdraw
the filament, at this moment, the extruder is still over 200°C, first push the filament in a little
further, and then directly pull it out.
If you want to change another color filament, first you need to withdraw filament and then
load in. Please do as following shown to avoid filament jam.
1) Turn on the Creator Pro, the display will indicate:
Build from SD
▶ Preheat
Utilities
2) Using the directional arrow buttons in the right of the screen to select Preheat,
OK
Press key on the keypad, then you will see：
▶ Start Preheating
Right Extruder
Left Extruder
Platform
3) Press page down
key, you will see：
▶Start Preheating
Right Extruder
Left Extruder
Platform
page up
4) Press
Creator Pro User Guide | www.FlashForge.com
OK
key until it does.
OFF
OFF
OFF
key to select Left Extruder (or Right
ON
ON
OFF
Start Preheat,
key back to
OK
and Press
46
Extruder), press OK
key, you will see:
400-699-1063