Flashforge Finder User Manual page 39

perpendicular rings appear around the object Click one ring and rotate on the present
axis, you will see the rotation angle and direction in the center of circle. In this way,
you could make the model rotate on X/Y/Z axis.
Method 2: Click the
angel values in X/Y/Z axes positioning. Click
5.1.7
Scale
Select the target object and scale the object by the following two methods:
Method 1: Click the
and scale the model. The corresponding values will display near the object..
Method 2: Click the
in X/Y/Z axes positioning. Click the
for building. Click [Reset]
Note: If the [Uniform Scaling]
proportion when changing
only change the value of the corresponding positioning.
5.1.8
Cut
Left-click on the model to select it and double-click on the Cut icon to set the cut
plane. The direction and position are available for setting.
①Draw with Mouse
Finder User Guide | www.ff3dp.com
[Rotate]
icon
[Scale]
icon
[Scale]
icon
[Maximum]
to reset the size of model.
radio button is clicked, it will scale the model in equal
value
in any positioning of the model. Otherwise it will
on the left, and then enter into rotating
[Reset]
to reset rotating angel values.
on the left, hold down the left mouse button
on the left and then enter into scale values
button to get largest size possible
39