Flashforge Finder User Manual page 17

Servo On:
Actually, the present servo status is off.
And the servo's swing arm withdraws.
Tap '+' or '-' to adjust the status of swing
arm. Tap '+', the arm swings down while
tap '-' , the arm swings up.
Servo OFF:
Actually, the present servo status is on.
And the servo's swing arm withdraws.
Tap '+' or '-' to adjust the status of swing
arm. Tap '+', the arm swings down while
tap '-' , the arm swings up.
Status:
It displays the real-time status of the extruder
temperature, fan and filament.
About:
It displays the basic information about the
device.
17
Finder User Guide | www.ff3dp.com