Flashforge Finder User Manual page 45

b. Fill Pattern is the pattern of filling shape which effects printing duration.
c. Combine Infill: You can select the layers for combining according to the layer
thickness. The combined thickness should not exceed 0.4mm. "Every N layers" is for all the
infills while "Every N inner layers" is only for inner infills, which generally can save print
time.
● Speed
a. Print Speed is the moving speed of the extruder. Generally, the lower speed is,
the better print you will get. For PLA printing, 80 is recommended.
b. Support Print Speed is needed to set when choosing Slic3r as the
slice engine which can control the moving speed of the extruder when printing
the supports.
c. Travel Speed is to control the moving speed of the extruder under
non-printing Status during work. for PLA printing, 100 is recommended.
Note: Modify parameters settings to get better prints as different models need
different parameters.
● Temperature
Extruder Temperature: Recommended extruder temperature is 220℃.
Note: Different temperatures have subtle influences in prints. Please adjust the
temperature according to the condition in order to get a good print.
● Others
Pause At Heights: Allows users to pre-set a height in which the print will
suspend automatically. The function usually applied when you want to change the
Finder User Guide | www.ff3dp.com
45