Flashforge Finder User Manual page 38

④Show Model Outline
[View]--[Show Model
Click
object
⑤Show Steep Overhang
Click [View]--[Show Steep
model surface and horizontal line is within the overhang threshold value, the surface
has steep overhang and it becomes red in the software. Overhang threshold value
could be set as needed. The default value is 45 degree.
5.1.5
Move
Select the object and move the object by the following two methods:
Method 1: Click the
button and drag to adjust the location of the model in XY direction. Hold down the
Shift key, hold down the left mouse button and drag to adjust the location of the
model in Z direction. The distance and the direction of the movement shall be
displayed.
Method 2: Click the
Click [Reset] to reset distance values.
Note: Users shall click
ensure the model(s) be within the build area and on the build platform. If a specified
position is needed, only to click
5.1.6
Rotate
Select the target object and rotate the object by the following two methods:
Method 1: Click the
Finder User Guide | www.ff3dp.com
Outline], it will highlight the yellow border of the
Overhang]. When the intersection angle between the
[Move] icon
[Move] button on the left and then enter the distance value.
[Center] and [On Platform]
[On Platform].
[Rotate]
icon
38
on the left, hold down the left mouse
after the location adjustment to
on the left and three mutually