Unloading Filament - Flashforge Creator3 User Manual

Table of Contents

Advertisement

(4-8) Tap
[Filament]--[Load]
(4-9) After the extruder's temperature reaches 220℃, the printer will sound a beep to
prompt you to load the filament into the extruder.
(4-10) Insert the filament into the extruder at an upright angle. Then the filament will
be drawn through the extruder. Do not tap
steadily.

4.4 Unloading Filament

Creator3 User Guide | www.flashforge.com
4-9
4-10
[Cancel]
until the filament load the extruder
4-11
43
400-699-1063

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Creator3 and is the answer not in the manual?

Table of Contents

Save PDF