Flashforge Finder User Manual page 30

(5-2) After tapping [Yes], the extruder starts to move towards the first point and the
plate moves up and down to verify the distance between nozzle and plate.
5-3
(5-3) When directed that the distance is too big, please unscrew corresponding nut
under platform clockwise until hearing a steady beep and the [Verify] button appears.
5-4
5-4
(5-4) If the distance is appropriate, tap [OK] to second point leveling. If still not,
please follow the prompts to adjust again till you see [OK] button.
5-5
(5-5) Repeat steps 2 through 4 above to complete second and third points leveling and
30
Finder User Guide | www.ff3dp.com