Flashforge Finder User Manual page 44

④Supports: When print with model contains part hanging in the air or top-heavy,
support is necessary. Click
⑤Raft: This function will help the model to stick well on the platform.
⑥Wall: During dual color printing, this function will help to clear the leaking
filament of another extruder.
⑦Vase Mode: No capping for the model
⑧Resolution： You have three resolution solution(with default setting)to choose from,
high resolution is corresponding with slow printing speed, opposite for the low
resolution.For PLA printing, an extra solution "Hyper" is available.
⑨More options: Click
temperature. Different resolution solution is corresponding to different defaults, click
[Restore Defaults]
to back to default setting.
●Layer
a. Layer: Layer thickness of the printing model. With a small number, the
surface of the model will be more smooth.
b. First Layer Height: This is the first layer of the model, which will affect the
sticking performance between the model and platform. Maximize is 0.4mm, usually
the default is ok.
c. Shell: Contains of the outside shell number, capping layer number (under vase
pattern, top solid layer setting is invalid.)
● Primeter Shells: Maximize is 10
a. Top Solid Layer: Maximize is 10, minimum is 1.
b. Bottom Solid Layer: Maximize is 10, minimum is 1.
● Infill
a. Fill Density means fill rate.
Finder User Guide | www.ff3dp.com
[supports]
to create support part for the printing.
[More options] to set for layer, shell, infill, speed and
44