Unloading Filament - Flashforge Guider 2 Quick Start Manual

Unloading Filament

1. Pull filament guide tube out of filament intake,
leave filament 10cm to pull filament easily.
3. Tap [Filament].
Extruder
Press here
Please follow steps below if you need to unload filament in
daily use.
Push filament down through for 3 seconds
2. Tap [Tools].
Load
4. Tap [Unload].
Unload started, press down on the
spring lever and withdraw filament
Extruder
5. When heating to target temparture, press
spring presser and push filament down through
for 3 seconds, until you see steady filament
coming out from nozzle.
12
Unload
Done