Flashforge Finder User Manual page 7

· Filament Storage
All polymers degrade with time. Do not unpack until filament is needed. Filament
should be stored at room temperature:15-30℃ and in dry conditions.
Legal Notice
All the information in this document is subject to any amendment or change without
the official authorization from Flashforge.
FLASHFORGE CORPORATION MAKES NO WARRANTY OF ANY KIND WITH
REGARD TO THIS DOCUMENT, INCLUDING, BUT NOT LIMITED TO, THE
IMPLIED WARRATIES OF MERCHANTA- BILITY AND FITNESS FOR A
PARTICULAR PURPOSE.
Flashforge shall not be liable for errors contained herein for incidental consequential
damages in connection with furnishing, performance or use of this material
This document contains proprietary information protected by copyright.
Copyright © 2016 Flashforge Corp. All Rights Reserved
7
Finder User Guide | www.ff3dp.com