Unloading Filament - Flashforge Guider IIs Quick Start Manual

Unloading Filament

1. Tap [Tools].
Load
Unload started, press down on the
spring lever and withdraw filament
Extruder
3. Tap [Unload], extruder starts to heat. When heating to target temperature, press spring presser
and withdraw filament vertically after compressing filament for 3 seconds.
Please follow steps below if you need to unload filament in
daily use.
Unload
Done
2. Tap [Filament].
Extruder
Press here
10
Filament intake