Unloading Filament - Flashforge Inventor Quick Start Manual

Unloading Filament

Print
1. Tap [Tools].
Load Left
Unload Left
Load Right
Unload Right
3. Tap [Unload Left (or right)].
Unload begins, press down spring presser
and withdraw filament
L Extruder
5. When heating to target temparture, press
spring presser and push filament down through
for 3 seconds, until you see steady filament
coming out from nozzle.
Please follow steps below if you need to unload filament in
daily use.
Preheat
100%
230℃ / 230℃
Finish
Filament Level
Setting Status
2. Tap [Filament].
L Extruder
4. Extruder start to heat.
Press here
16
Home Manual
About
16%
25
℃ / 230℃
Cancel
Push Filament down
through for 3 seconds