Flashforge Finder User Manual page 27

(4-6) Tap [Tool].
(4-7) Tap [Filament]--[Load]
（4-8）After the extruder's temperature reaches 220℃, the printer will sound a beep
to prompt you to load the filament into the extruder.
（4-9）Insert the filament into the extruder at an upright angle. Then the filament will
be drawn through the extruder. Do not tap [Cancel] until the filament exits the
extruder steadily.
Finder User Guide | www.ff3dp.com
图 4-6
4-8
4-9
27