User Maintenance - Canon LBP710Cx User Manual

User Maintenance

*
Asterisks ( )
● Settings marked with an asterisk (
feeder or SD card (all of these being optional) is installed or not in the machine.
Adj. Print Position(P. 420)
Recovery Printing(P. 421)
Initialize Counter(P. 421)
Check Paper Size(P. 422)
Substitute Size(P. 422)
Auto Detect Ppr Type(P. 422)
Short Edge Fd. Prty.(P. 423)
Special Image Mode(P. 423)
Sp. Transfer Mode(P. 424)
Clr/B&W Switch Mode(P. 424)
Special Density Mode(P. 425)
SD Card Maintenance(P. 425)
Special Print Mode(P. 426)
Adj. Print Position
You can adjust the print position for each paper source.
Offset Y (2-Sided)
You can adjust the vertical print position for printing on the first page (front side) in 2-sided printing mode. The
print position on the second page (back side) follows the settings for the paper source available when the
printing is started.
-5.0 to 0.0 to +5.0 (mm)
Offset X (2-Sided)
You can adjust the horizontal print position for printing on the first page (front side) in 2-sided printing mode.
The print position on the second page (back side) follows the settings for the paper source available when the
printing is started.
Multi-Purpose Tray
-2.25 to 0.00 to +2.25 (mm)
Drawer 1 to 4 *
-2.25 to 0.00 to +2.25 (mm)
Setting Menu List
The settings about adjustment of the machine including print position correction
for each paper source and print quality improvement are listed with short
descriptions. You can specify those settings when the machine is offline. Default
settings are marked with a dagger ( ).
*
) are not displayed depending on other settings and whether the paper
Special Print Adj. C(P. 430)
Adjust Barcode(P. 430)
Update Firmware(P. 430)
First Calibration(P. 431)
Paper Feed Method(P. 432)
Show Job List(P. 432)
Import/Export Set.(P. 433)
Calibration Freq.(P. 434)
Notify to Clean(P. 434)
Clean. Notif. Timing(P. 434)
Toner Check Timing(P. 434)
Spec Tnr Chk Timing(P. 435)
Adjusting Print Position(P. 582)
420
0YSF-05L