Table of Contents
Advertisement
(
)
Settings>
hard reset (
LPD Settings
Enable or disable LPD, a printing protocol that can be used on any hardware platform or operating system. Also,
set the time period after which the print job automatically ends when print data cannot be received due to a
communication error or some other problem. Use the Remote UI to specify settings for banner page printing
when LPD is enabled.
Configuring Printing Protocols and WSD Functions(P. 200)
LPD Print
Off
On
(
)
Settings>
Performing a Hard Reset(P. 498) )
*
RX Timeout
1 to 60
(min.)
(
)
Settings>
Performing a Hard Reset(P. 498) )
RAW Settings
Enable or disable RAW, a Windows specific printing protocol. Also, set the time period after which the print job
automatically ends when print data cannot be received due to a communication error or some other problem.
Use the Remote UI to specify settings for bidirectional communication.
WSD Functions(P. 200)
RAW Print
Off
On
Setting Menu List
<Network>
Check the message
<FTP>
<Allow Set. via FTP>
Performing a Hard Reset(P. 498) )
<Network>
Check the message
<LPD Print>
<Network>
Check the message
<RX Timeout>
383
<TCP/IP
<Off> or <On>
<TCP/IP Settings>
<Off> or <On>
Perform a hard reset (
<TCP/IP Settings>
Set Timeout Time
Configuring Printing Protocols and
Perform a
<LPD
<LPD
Perform a hard reset (
Advertisement
Table of Contents
