Canon LBP710Cx User Manual page 311

Select the type of the IP address of the machine to apply the policy from the following list.
[All IP Addresses]
[IPv4 Address]
[IPv6 Address]
[IPv4 Manual Settings]
[IPv6 Manual Settings]
[Addresses to Set Manually]
If [IPv4 Manual Settings] or [IPv6 Manual Settings] is selected for [Local Address], enter the IP address to
apply the policy.
[Subnet Settings]
When manually specifying IPv4 addresses, you can express the range by using the subnet mask. Enter the
subnet mask using periods to delimit numbers (example:"255.255.255.240").
[Remote Address]
Select the type of IP address of the other devices to apply the policy from the list shown below.
[All IP Addresses]
[All IPv4 Address]
[All IPv6 Address]
[IPv4 Manual Settings]
[IPv6 Manual Settings]
[Addresses to Set Manually]
If [IPv4 Manual Settings] or [IPv6 Manual Settings] is selected for [Remote Address], enter the IP address to
apply the policy.
[Subnet Settings]
When manually specifying IPv4 addresses, you can express the range by using the subnet mask. Enter the
subnet mask using periods to delimit numbers (example:"255.255.255.240").
[Local Port]/[Remote Port]
If you want to create separate policies for each protocol, such as HTTP or SMTP, enter the appropriate port
number for the protocol to determine whether to use IPSec.
● IPSec is not applied to the packets that have a specified multicast or broadcast address.
8
Specify the IKE Settings.
Security
Select to use IPSec for all IP packets.
Select to use IPSec for all IP packets that are sent to or from the IPv4 address of the
machine.
Select to use IPSec for all IP packets that are sent to or from an IPv6 address of the
machine.
Select to specify a single IPv4 address or a range of IPv4 addresses to apply IPSec.
Enter the IPv4 address (or the range) in the [Addresses to Set Manually] text box.
Select to specify a single IPv6 address or a range of IPv6 addresses to apply IPSec.
Enter the IPv6 address (or the range) in the [Addresses to Set Manually] text box.
Select to use IPSec for all IP packets.
Select to use IPSec for all IP packets that are sent to or from an IPv4 address.
Select to use IPSec for all IP packets that are sent to or from an IPv6 address.
Select to specify a single IPv4 address or a range of IPv4 addresses to apply IPSec.
Enter the IPv4 address (or the range) in the [Addresses to Set Manually] text box.
Select to specify a single IPv6 address or a range of IPv6 addresses to apply IPSec.
Enter the IPv6 address (or the range) in the [Addresses to Set Manually] text box.
305