Table of Contents
Advertisement
1
Select the [Use Filter] check box and click the [Reject] or [Allow] radio button for the [Default
Policy].
[Use Filter]
Select the check box to restrict communication. Clear the check box to disable the restriction.
[Default Policy]
Select the precondition to allow or reject the communication of other devices with the machine.
[Allow]
[Reject]
2
Specify address exceptions.
●
Enter the IP address (or the range of IP addresses) in [Register Address] and click [Add].
Check for entry errors
●
If IP addresses are incorrectly entered, you may be unable to access the machine from the Remote UI,
in which case you need to set <Address Filter> to <Off>.
When you have selected [Reject] under [Default Policy]
●
Neither multicast packets nor broadcast packets can be filtered.
Deleting an IP address from exceptions
●
Select an IP address and click [Delete].
3
Click [OK].
For RX Filter
When selecting [Allow] under [Default Policy], specify the IP addresses of devices whose communication with the
machine should be blocked. When selecting [Reject] under [Default Policy], specify the IP addresses of devices that
should be able to communicate with the machine.
Security
Select to block communication packets when they are sent to or received from
devices whose IP addresses are entered in [Exception Addresses]. Communications
with other devices are permitted.
Select to pass communication packets only when they are sent to or received from
devices whose IP addresses are entered in [Exception Addresses]. Communications
with other devices are prohibited.
270
Address Filter(P. 395)
Advertisement
Table of Contents
