Table of Contents
Advertisement
Specifying IP Addresses for Firewall Rules
You can either limit communication to only devices with specified IP addresses, or block devices with specified IP
addresses but permit other communications. You can specify a single IP address or a range of IP addresses. For data
reception, you can specify IP addresses by specifying port numbers.
●
Up to 16 IP addresses (or ranges of IP addresses) can be specified for both IPv4 and IPv6.
●
The maximum number of port numbers that can be specified for a single IP address is 50.
●
The packet filters described in this section control communications over TCP, UDP, and ICMP.
1
Start the Remote UI and log on in Management Mode.
2
Click [Settings/Registration].
3
Click [Security]
4
Click [Edit] for the filter type that you want to use.
Security
[IP Address Filter].
268
Starting Remote UI(P. 336)
0YSF-045
Advertisement
Table of Contents
