To Use The Counter Function; Video Process Bypass Mode; Differences In Camera Operation; To Enable Video Process Bypass Mode - IAI GO-2401M-PGE User Manual

■ To use the counter function

Configure the settings as follows.
Three counters can be configured (Counter 0 to 2).
Item
Counter 0 to 2
Counter 0 to 2 Event Source
Counter 0 to 2 Event Activation
Note
The four counter event signals are always counted up internally on the camera.

Video Process Bypass Mode

The video process bypass mode is a function that bypasses internal video processing on the camera.
When bypass is enabled, the sensor output and camera output data can be set to the same bit width.
Operation using 12-bit outputs must be performed in bypass mode.
Video process bypass mode
Camera operation
Camera output

■ Differences in camera operation

When video process bypass mode is disabled
All video processes are enabled.
Sensor Block
Gain All
When video process bypass mode is enabled
All video processes except Gain all (excluding R/B Gain) and Blemish Compensation are disabled.
Sensor Block
Gain All

■ To enable video process bypass mode

Item
Video Process Bypass Mode
Setting value / selectable range
Counter 0 to 2
Off,
Frame Trigger,
Frame Start,
Exposure Start,
Exposure Transfer End
Rising Edge (fixed)
or Falling Edge
All video processes except Gain all
(excluding R/B Gain) and Blemish
Compensation are disabled.
8-/10-/12-bit
Black Level Pixel Gain
Block Block
R/B Black
Level R/B Gain
Setting value / selectable range
On
On
Blemish
Comp Block
Blemish Comp
Blemish
Comp Block
Blemish Comp
— 44 —
GO-2401M-PGE / GO-2401C-PGE
Description
Select the counter.
Select the counter event signal for
which to read the count value.
Specify the timing at which to count.
Off
All video processes are enabled.
8-/10-bit
Shading/ BlackSetup
Block
LUT Block
LUT
Black Setup
Description
Enable video process bypass
mode.