Voip Settings; Voip Server Settings - Yeastar Technology TG Series User Manual

DID Associated
Number
Enable Call Back
Hotline
Two Stage Dial
Dial Pattern Template

4.2 VoIP Settings

To integrate with other IPPBX, we need to configure the VoIP settings in NeoGate TA to
setup VoIP trunk (SIP and IAX).

4.2.1 VoIP Server Settings

There are some configurable VoIP (SIP/IAX) Server templates on this page. The number
of VoIP Server templates is the half of FXO ports on NeoGate. The VoIP server settings
help the FXO ports to register to the VoIP server. Once configured, the templates can be
chosen on FXO port setting page.
Two modes are available for the VoIP server, we call them VoIP mode and SPS (Service
Provider SIP)/SPX (Service Provider IAX) mode.
VoIP Mode:
The FXO port will be registered as one the VoIP server's SIP extensions if "Enable
Register" is checked on VoIP Server template.
SPS/SPX Mode:
If "Enable Register" is not checked, the FXO port will be registered as a SPS/SPX trunk to
the VoIP Server. One SPS/SPX trunk to NeoGate TA also should be created on the VoIP
Server.
no DID info. You can also use pattern matching to match a
range of numbers.
Define the extension for DID number. You can only input
number and "-" in this field, and the format can be xxx or
xxx-xxx. The count of the number must be only one or equal the
count of the DID number.
Choose whether call back is enabled. NeoGate TA allows caller
A to dial an inbound route number, and after hearing the ring,
Acan hang up the call cut off the call, then NeoGate TA will call
back to A.
Set the hotline number. If hotline number is configured, TA will
route the incoming call to the hotline number directly.
Enable it to get the customized two stage dial tone before
dialing out, it's disabled by default.
Choose the Dial Pattern template.
NeoGate TA410/810 User Manual
38/51