Select Audio Jingle For Good Read Event - Datalogic Cobalto C05300 Product Reference Manual

Enter/Exit Programming Mode
Select Audio Jingle for Power-up Event — cont.
$CAUPW0D
Audio Jingle on Power-up = Jingle #13
$CAUPW0F
Audio Jingle on Power-up = Jingle #15

Select Audio Jingle for Good Read Event

This parameter selects which preloaded Jingle
NOTE
After uploading up to fifteen (15) Jingles to the scanner using the Aladdin
utility, use this setting to designate which of the Jingles (1-15) will be sounded when the
scanner performs a good read.
DEFAULT
$CAGRW01
Audio Jingle on Good Read = Jingle #1
1. A "Jingle" is a short, user-defined tune uploaded via Datalogic Aladdin™ configuration software.
70


Audio Jingle Enable on page 67
The previous option,
this selection to take effect.
Audio Jingle on Good Read = Use built-in Good Read

Select Audio Jingle for Good Read Event
$CAUPW0E 
Audio Jingle on Power-up = Jingle #14
1
to use in indicating a good read event.
, must be enabled for
$CAUGR00 
Jingle (Shutter.wav)
Cobalto™ CO5300 Scanner
TM
configuration