Bc412 Set Length 2 - Datalogic Cobalto C05300 Product Reference Manual

Enter/Exit Programming Mode

BC412 Set Length 2

This feature specifies one of the bar code lengths for
maximum label length if in
Length
length does not include start/stop characters.
The length can be set from 1 to 50 characters. A setting of 00 specifies to ignore this length
(only one fixed length). See
instructions.
Select BC412 Length 2 Setting
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
208
Variable Length
Mode. Length includes the bar code's check, data, and full-ASCII shift characters. The
"Set Length 2"
$CBCL2
DEFAULT
BC412 Length Control
Mode, or the second fixed length if in
on page 241 for more detailed programming
To configure this feature, scan the ENTER/EXIT bar
code above, then the bar code at left followed by dig-
its from the Alphanumeric characters in
Keypad
representing your desired character(s). End
by scanning the ENTER/EXIT bar code again.
50 = Length 2 is 50 Characters
. Length 2 is the
Fixed
Appendix D,
~
CANCEL
Cobalto™ CO5300 Scanner
BC412