Disable Character - Datalogic Cobalto C05300 Product Reference Manual

References

Disable Character

Specifies the value of the RS-232 host command used to disable the scanner.
ASCII characters or any hex value from 0 to 0xFF can be selected.
To set the value:
1. Determine the desired character or value. A setting of 0xFF indicates the Disable Charac-
2. Use the
3. Go to
4. Scan the bar code: SELECT DISABLE CHARACTER SETTING.
5. Scan the appropriate two alphanumeric characters from the keypad in
6. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Programming Mode.
This completes the procedure. See the table below for examples of how to set this feature.
Table 11. Disable Character Setting Examples
STEP ACTION
1 Desired character/value
Hex equivalent from
2
Chart
3
4
Scan Two Characters From
5
Appendix D, Keypad
6
224
Setting to previously defined characters such as XON, XOFF, or host
commands conflicts with normal operation of these characters. 8-bit
data is not recognized when the option
Data Bits.
NOTE
ter is not used (not available).
ASCII Chart on the inside back cover of this manual to find the hex equivalent for
the desired character/value.
page 30 and scan the ENTER/EXIT PROGRAMMING MODE bar code to enter Pro-
gramming Mode.
that represent the desired character/value determined above. The second character will
cause a two-beep indication.
'd'
ASCII
0x64
Scan ENTER/EXIT PROGRAMMING MODE
Scan SELECT DISABLE CHARACTER VALUE SETTING
'6' and '4'
Scan ENTER/EXIT PROGRAMMING MODE
Stop Bits
EXAMPLES
'}' 'D'
0x7D 0x44
'7' and 'D' '4' and '4'
Cobalto™ CO5300 Scanner
has been set as 7
Appendix D, Keypad,
Disable Command
Not Used
0xFF
'F' AND 'F'